|
|
|
|
- When the Aura is un-cocked it may be opening the valve.
- Valve cup seal is defective.
- Outer seals on the valve body are defective.
|
- Re-cock the Aura.
- Replace valve cup sea.l
- Replace outer valve body seals.
|
- Balls are breaking in the barrel.
|
- Is the ball sensor on?
- Is there a ball sensor error?
- Ball detents are not working.
- Barrel bore may not be matched for the size of the paint.
- Paint may be too fragile.
|
- Turn the ball sensor on.
- Clear the ball sensor error.
- Clean/ replace ball detents and check the ball detent springs.
- Find a suitable barrel for the size of paint.
- Use a tougher grade of paint.
|
|
- Regulator needs cleaning.
- Poor quality paintballs being used.
- Barrel bore not matched to the size of the paint.
- ON-OFF valve is not pushing the pin of the pin valve attached to the air tank.
|
- Tighten ON-OFF knob fully clockwise.
- Check that the pin on the pin valve is not too low.
- Liquid CO2 may be entering the regulator.
- Use a CO2 tank with an anti-siphon tube or use compressed air or nitrogen.
|
- Velocity is extremely high and cannot be lowered.
|
- Upper o-ring on the adjustment screw needs replacing.
|
|
- The Aura leaking out of the regulator.
|
- Out of the vent hole.
- Out of the adjustment screw.
|
- Replace 018 and 008 o-ring.
- Replace adjustment screw o-rings.
|
- Leaking out of the vent hole in the front cap.
|
- Defective o-ring on the valve stem guide.
|
- Remove valve assembly and replace o-ring (part #8).
|
- Leaking out of the front cap.
|
- Defective front cap o-ring.
|
- Remove front cap and replace o-ring (part #10).
|
