|
|
|
- The Aura does not fire and no error is showing.
|
|
- Select one of the firing modes.
|
- The Aura does not fire and the error light is flashing three times.
|
- There are no paintballs detected by the sensors.
|
- Add more paintballs to the loader.
|
- The Aura does not fire and the error light is flashing three times then solid.
|
- The bolt is jammed.
- Ball sensor is dirty.
- The solenoid is not releasing the hammer.
- Software has crashed.
|
- Remove the bolt and clean the receiver.
- Clean the ball sensors.
- Replace the battery.
- Clean the solenoid.
|
- The Aura is not re-cocking.
|
- Velocity set too low.
- Hammer seal is defective.
- Dirt inside receiver.
|
- Increase velocity.
- Replace hammer seal.
- Remove bolt and hammer and clean inside of the receiver.
|
- The Aura is chopping paint.
|
- Is the ball sensor on?.
- Is there a bell sensor alarm?.
- Sear is defective.
- Hammer is defective.
|
- Turn the ball sensor on.
- Refer to ball sensor alarm troubleshooting.
- Replace the sear.
- Replace hammer.
|
- The Aura fires but the bolt does not move.
|
- Cocking pin is not aligned with the hammer.
|
- Refer to Replacing the bolt in the maintenance section.
|
- The battery life is short.
|
- If the Aura is not used for awhile the battery will drain.
- Poor grade battery.
|
- Remove the battery when not using the Aura.
- Use a high grade alkaline or lithium battery.
|
- The solenoid is moving but the Aura will not fire.
|
- Weak battery.
- Solenoid assembly is jammed or dirty.
|
- Replace battery.
- Clean and lubricate solenoid assembly.
|
